Install fuel pump 1991 dodge dakota

IP: Logged Message: You're not gonna have the return line for the fuel on the '92 Dak, so you'll need to plumb one in, or run an in-line electric pump for carburetor use lower psi. The Magnum system uses way too much pressure to run straight to a carb. Otherwise, the swap is the same. IP: Logged Message: thank you! Pretty much any will work per your question. Its one of the most desirable years for modified Daks. IP: Logged Message: my 93 92' are exactly same as 93' is a return style fuel system.

IP: Logged Message: I stand corrected. I'd always read that part of the Magnum fuel system was the returnless fuel line arrangement, but I was looking at my '93 service manual, and sure enough, they still had them. Maybe they went returnless in 94?

I am doing an off frame restore on it. Post a reply to this message: Username Registration: Optional All visitors are allowed to post messages Name:. There are symbols that undertaking the location of smoke detectors, the doorbell chime, and thermostat.

A set of wiring diagrams may be required by the electrical inspection authority to take on board relationship of the house to the public electrical supply system. Wiring diagrams will with supplement panel schedules for circuit breaker panelboards, and riser diagrams for special facilities such as flame alarm or closed circuit television or supplementary special services.

Wire Diagram for thermostat Wiring Diagram views. Park the Dodge in a well-ventilated area and turn off the key. Open the fuse box under the dash and unplug the fuel relay. Start the Dakota and run it until it stops. This will relieve the fuel pressure. Open the engine compartment and disconnect the negative cable from the battery.

Raise the rear end of the Dodge with the automobile jack. Place a jack stand under it and raise it up to the frame. Disconnect the fuel line using a wrench and drain the gas into the drain pan.

Remove the mounting bolts from the fuel tank brackets using a socket and ratchet. Lower the gas tank to the ground. Unplug the wiring harness from the fuel pump at the gas tank.