How to setup wireless wds repeater

For this example, we will configure the 2. So, if your host router has an IP address of Scroll down to the wireless section and enter the exact same settings that you entered on the host router.

The SSID, channel, security type and password must match the settings on the host router. TIP: If you are unable to establish a WDS link between the two routers, try temporarily disabling encryption on both routers. If you are still unable to establish a link, double check that you have correctly entered the MAC address of each router, on the other router. In this mode, one wireless transmitter will facilitate both a wireless access point, and a WDS bridge link.

TIP: Since you are working with two routers, remember to be careful when logging in and out of each router. In order to prevent a mistake, power down the router and disconnect the cables.

Now, connect the cables and power on the primary router. I recommend rebooting your primary router first. Wait a few minutes and then power up your client router. Whether the second router is upstairs, downstairs, or across the street, put your laptop or other wireless device near the secondary router. You should notice a substantial increase in wireless coverage. Now, when you connect to your wireless network, the primary router will assign a dynamic IP address to your client computer, even though you may be connected to the network via the secondary router.

The secondary router is merely extending coverage. What is a WDS Bridge? Multipoint wireless bridge. Repeater bridge. WDS allows a wireless network to be expanded using multiple access points without the need for a wired backbone to link them.

To establish a WDS link, the device and other remote WDS peers must be configured in the same wireless network mode, wireless channel, wireless band selection, and encryption types None or WEP. Bridge mode is useful if you want the other APs to extend the network signal for your device, which acts as the common link. Repeater mode is useful if you want your device to act as a network signal repeater for other APs by using a wireless connection. Step 1. The WDS page opens:.

Step 3. Step 4. The WDS page opens. Choose the desired option for the WDS Repeater mode.